Haier CO2 Incubator

Bullseye PREMIUM HS-Taq DNA Polymerase Master Mix with HS Buffer I

Store at -20°C. For in-vitro laboratory use only

Bullseye HS Taq Polymerase, 2X Mix is a ready-to-use 2.0X master mix. Simply add primers, template, and water to successfully carry out primer extensions and other molecular biology applications.

Bullseye HS Taq Polymerase Mix, the NH4+ buffer system, dNTPs and magnesium chloride are present in HS Taq Pol Mix with HS Buffer I. Each reaction requires 25 µL of the 2.0X reaction mix. Simply add primers, template and water to a total reaction volume of 50 uL.

Bullseye HS Taq Polymerase Mix is a modified form of Bullseye Taq DNA Polymerase, which is activated by heat treatment. A chemical moiety is attached to the enzyme at the active site, which renders the enzyme inactive at room temperature. Thus, during setup and the first ramp of thermal cycling, the enzyme is not active and misprimed primers are not extended. The result is higher specificity and greater yields when compared to standard DNA polymerases.

Bullseye" HS Taq Polymerase Mix offers several advantages. Set up time is significantly reduced. The chance of contaminating component stocks is eliminated. Reduction of reagent handling steps leads to better reproducibility. Standard tests can be set up with the confidence that results will be consistent every time.

Composition of HS Taq Pol, 2x Mix

Tris-HCl pH 8.5, (NH4)2S04, 3.0mM MgCl2, 0.2% Tween 20Ã, 0.4 mM dNTPs, 0.2 units/uL HS Hot Start DNA Polymerase Stabilizer

Suggested Protocol using HS Taq Pol, 2x Mix

This protocol serves as a guideline only. Optimal reaction conditions may vary and must be individually determined.

• Set up reaction mixtures in an area separate from that used for DNA preparation or product analysis.
• The table below shows the reaction set up for a final volume of 50 mL.
• Important: Mix the solutions completely before use to avoid localized concentrations of salts.

  1. Set up each reaction as follows: