CheckIT Pipettor Accuracy Tester

• Validate the accuracy of your liquid handling robots or multi-channel pipettes daily or weekly.
• Quickly and easily measure the accuracy of your robot or multi-channel pipette.
• Concerned that a robot or a pipette was misused or needs calibration? Just Checkit. 

The Checkit Go is an easy-to-use, stand-alone, disposable cartridge that allows you to check the accuracy of your liquid handling robot or multi-channel pipette in just seconds. No additional equipment is required. The Checkit Go is interchangeable with well plates, so it works with all robots that handle 96 well plates. Compatible with all makes of multi-channel or electronic pipettes.

This simple device measures the dispensed volumes of up to 8 channels simultaneously. It is the size of a well plate, so you can use it in your robot or on a lab bench. You're done in under 10 seconds. That means no more trying to read a tiny droplet's weight on a high-precision balance and repeat for seven more channels.

The Checkit Go directly measures the volume of the liquid dispensed, not an indirect measurement of the weight or the color change of a liquid. In addition, the Checkit Go limits evaporation to negligible levels because the dispensed droplets are encased in glass tubes within seconds. Measurements are guaranteed to be accurate to within 2% and typically better than 1%.

Easy to Use

Just aspirate the included dye. Dispense the dye into the wells on the flip tab of the cartridge. Flip the tab, or let the robot flip the tab. Then, watch the dye travel up the 8 channels simultaneously. Finally, compare the level of the dye against the graduations. You can record the measurement with a simple photo.

The disposable cartridge shows the measured volume directly on the cartridge. Just compare the level of dye against the graduations without any expensive balances or spectrophotometric equipment.